After designing the following warning is issued by STAAD :
*** WARNING: LENGTH TO DEPTH RATIO FOR MEMBER 8 IS LESS THAN 2.5.
*** WARNING: LENGTH TO DEPTH RATIO FOR MEMBER 283 IS LESS THAN 2.5.
*** WARNING: LENGTH TO DEPTH RATIO FOR MEMBER 482 IS LESS THAN 2.5.
*** WARNING: LENGTH TO DEPTH RATIO FOR MEMBER 498 IS LESS THAN 2.5.
The above list of members are those required for the designing. But in a model there may be many members with L/d Rtion less than 2.5.
How to find or list out all the members with L/d ratio less than 2.5 in any RC frames or model?