Karl,
I had a similar question, except with ACI 318. I have a top and bottom mat of user reinforcement specified in each direction of a 2-way slab. Therefore, I specified the top and bottom reinforcement with a slab face of "Both" so that both layers are accounted for with the minimum reinforcement. However I still get additional bars and have thus set CS and MS Span Detailer to "None". Are there any potential problems that could arise from doing so?
Thank you.
I had a similar question, except with ACI 318. I have a top and bottom mat of user reinforcement specified in each direction of a 2-way slab. Therefore, I specified the top and bottom reinforcement with a slab face of "Both" so that both layers are accounted for with the minimum reinforcement. However I still get additional bars and have thus set CS and MS Span Detailer to "None". Are there any potential problems that could arise from doing so?
Thank you.