Thanks for the response and reference faq link, Geeky.
I tried with removing truss specification and assigning partial moment release (starting with Mp 0.99 to Mp 0.8). The displacement is reduced to 10^12 in from 10^24 in, but it's still unstable. (almost same numbers of warnings as before)
As you were able to run the model without any instability warnings :
Did you make any changes in the model?
If yes, could you please share edited/changed file?
Are you using basic solver or advanced analysis solver?
I am using basic solver.
Thanks,
Madhav
I tried with removing truss specification and assigning partial moment release (starting with Mp 0.99 to Mp 0.8). The displacement is reduced to 10^12 in from 10^24 in, but it's still unstable. (almost same numbers of warnings as before)
As you were able to run the model without any instability warnings :
Did you make any changes in the model?
If yes, could you please share edited/changed file?
Are you using basic solver or advanced analysis solver?
I am using basic solver.
Thanks,
Madhav
