Thanks.
In service and stress load combination will be same so I used same load combinations in different envelopes.
In engineering calculation there is no restrictions to use one combination for different type of designs. The why STAAD is restricted?
Even if that is restricted how it shows "service envelope not provided". I have clearly defined service envelope then why STAAD showing the below warning.
**WARNING- Deflection check of member # 4 will not be performed as service envelope not provided.
In service and stress load combination will be same so I used same load combinations in different envelopes.
In engineering calculation there is no restrictions to use one combination for different type of designs. The why STAAD is restricted?
Even if that is restricted how it shows "service envelope not provided". I have clearly defined service envelope then why STAAD showing the below warning.
**WARNING- Deflection check of member # 4 will not be performed as service envelope not provided.