If you have a different version of the program then the manual section numbers can be different. I was referencing the v6 manual, in the chapter "EC2 Code Implementation"
7.3 can certainly control the final reinforcing you get. In the design strip properties, there is a setting for CS - PT Service Design Type = Crack Width or Stress (or both) that has an impact here. When Crack Width control is in place the program will add bars to control cracking. The environment also plays a role.
7.3 can certainly control the final reinforcing you get. In the design strip properties, there is a setting for CS - PT Service Design Type = Crack Width or Stress (or both) that has an impact here. When Crack Width control is in place the program will add bars to control cracking. The environment also plays a role.