The boundary element extents are only checked if the wall has been defined as a "Special Reinforced Concrete Structural Wall" in the Criteria - Design Criteria dialog. If the "Ordinary Reinforced Concrete Structural Wall" toggle is selected, then the boundary extents checks are not completed. The tie/link design is completed for either wall type.
In my test run, I was able to get a tie/link design for a boundary zone within an Ordinary Reinforced Concrete Wall. Based on your description, it appears that the program is not designing these. Please share your model and we will review those design warnings. You can use the Secure File Upload link at the bottom of the page. Please reply back with the file name after it is uploaded.
In my test run, I was able to get a tie/link design for a boundary zone within an Ordinary Reinforced Concrete Wall. Based on your description, it appears that the program is not designing these. Please share your model and we will review those design warnings. You can use the Secure File Upload link at the bottom of the page. Please reply back with the file name after it is uploaded.