when you built a structural model or if you have STAAD model and you want to add a new member and assign new steel section, an error will happen that the section property material for new added members will not go to the supposed location in the STAAD file (after the other previously defined sections like previous version of STAAD) but it will put the property definition after load definition and when run the analysis STAAD will think that these new members don't have been defined. Then you need to go and cut and paste these lines and put them where it should be............................Please STAAD pro team, I told you last time you need to test the software before issue it (when I discovered a problem in AISC 360-10 compression/ tension member design- and you were dishonest that you never mentioned that correction after releasing patch)
↧