Hi Suro,
I am able to define Seismic type - 11 (IS 1893). But when i try to add self weight, it is not processing as the Zone factor is 0.
There needs to be some function after seismic definition so as to enable the application of self weights joint weight etc.
If i add manually the zone factors etc then the load functions work properly.
Hope i was bit clear. Request your grateful support on the same.
I am able to define Seismic type - 11 (IS 1893). But when i try to add self weight, it is not processing as the Zone factor is 0.
There needs to be some function after seismic definition so as to enable the application of self weights joint weight etc.
If i add manually the zone factors etc then the load functions work properly.
Hope i was bit clear. Request your grateful support on the same.